JI1FGX/DU9 Mindanao, Philippines Amateur Radio Diary IOTA OC-130
English Japanese



Access until yesterday
Introduction. 【【Lily Diary]
Diary of Life in Mindanao

10/12/31 TV antenna fabrication
10/12/24 Cute operator
10/12/23 Business and broadcasters consult with us.
10/12/17 Business Antenna Construction
10/12/15 Antennas found in the city
10/12/10 14MHz antenna repair completed
10/12/07 14MHz antenna destruction
10/12/04 Fare8 Club Christmas Party
10/12/04 Gigi Class C Retake
10/11/27 To Manila, PARA's General Assembly
10/11/16 A piglet was born.
10/11/06 Ham Shop Situation
10/11/02 Internet connection is not available
10/10/27 STANDARD C150 repair
10/10/22 Ham Shop Page
10/10/22 power outage
10/09/30 Autumn Condition
10/09/17 DU8UTP Franco.
10/09/12 Challenge PSK 31
10/09/07 Expansion of piggery
10/08/12 Antenna repair for 21 MHz
10/08/07 The 21 MHz antenna is broken.
10/08/06 Backyard and Antenna
10/08/03 sunset
10/07/31 Radio Commercials
10/07/03 Shack Introduction
10/06/21 Repeater Controller
10/06/07 Repeater Controller CW Routine
10/05/20 Clear sky, group of antennas
10/05/18 antenna group
10/05/13 50MHz also open
10/05/09 Election...eh! Are you sure?
10/05/06 How to write a card via manager
10/05/04 shack
10/04/20 VHF Repeater Orders Received
10/04/12 Philippine Military Group
10/04/11 business
10/04/05 21MHz and 50MHz antennas
10/04/04 Failed 50MHz installation
10/04/04 If not available, make one. 50MHz balun
10/04/02 If you don't have it, make it. Cross mount.
10/04/01 50MHz 5EL remanufactured
10/03/23 Four 16-meter-long bamboos
10/03/22 Production of 21MHz 3-element yagi
10/03/15 Purchase a generator
10/03/05 wire antenna
10/02/03 Broken again.
10/01/20 I'm going in the wrong direction.
10/01/19 18MHz Yagi breakage for Japan
10/01/04 7/8 2-stage 144MHz band GP
JI1FGX/DU9 Mindanao Diary50MHz installation failure（2010/04/04)
I set up a temporary installation in a coconut tree and measured using an antenna analyzer and got the target value in one shot!
I'm so happy I'm carrying it to the pole tower myself.
However, it is difficult to raise the antenna on a stator tower.
The stay element is stuck and cannot be raised properly even with a rope.
So I thought of a way to lift it up by sliding it over the top stay.
That's pretty good.
A pulley pulls it up from below and it goes up smoothly.
However, there was a problem at the end
I left the cross mount on so it was too heavy to level properly.
After all, one of the elements was broken, and today's work was cancelled.

Tomorrow I'll attach the cross mount to the pole first and then lift it up again using the sliding method.
But first, we need to replace the broken element.
April 04, 2010   April 05, 2010